![]() ![]() ![]() This procedure assumes you want to use ASDM to manage the ASA FirePOWER Module. See the ASDM release notes on for the requirements to run ASDM. Press the Enter key to see the following prompt: Launch a terminal emulator and connect to the ASA.ģ. ![]() You might need to use a third party serial-to-USB cable to make the connection.Ģ. Connect your computer to the ASA console port with the supplied console cable. To achieve the above configuration, perform the following steps.ġ. You should consider this interface as completely separate from the ASA in terms of routing. Only configure an IP address in the module configuration. Note : Do not configure an IP address for this interface in the ASA configuration. The ASA FirePOWER can then use this interface to access the ASA inside network and use the inside interface as the gateway to the Internet. The interface is Up, but otherwise unconfigured on the ASA. Management 0/0 belongs to the ASA FirePOWER module.This procedure lets you connect to the ASA console port and paste in a new configuration that configures the following behavior: Be sure to configure appropriate routes on the ASA and on the ASA FirePOWER so the management network can reach the inside network, and vice versa. In this case, configure the ASA and the ASA FirePOWER Management 0/0 IP addresses to be on the same network. Note: If you have an inside router instead of a switch, you can skip this section and instead configure the ASA to route between management and an inside network. To install the Control and Protection licenses and other optional licenses, see Install the Licenses. See also the Cisco Firepower System Feature Licenses. See the Cisco ASA with FirePOWER Services Ordering Guide for ordering information. These licenses do generate a PAK/license activation key for the ASA FirePOWER module. Other licenses that you can purchase include the following: Note: This right-to use subscription does not generate a PAK/license activation key for the ASA FirePOWER module. IPS-This includes entitlement to Rule, Engine, Vulnerability, and Geolocation updates.For the right to use updates for the Protection (IPS) feature, you need to purchase the following subscription from : The right to updates for the Control (AVC) feature is included with a Cisco support contract. Control and Protection-Control is also known as “Application Visibility and Control (AVC)” or “Apps”.No licenses are pre-installed, but the box includes a PAK on a printout that lets you obtain a license activation key for the following licenses: The ASA FirePOWER module uses a separate licensing mechanism from the ASA. To install additional licenses on the ASA, see the ASDM Configuration > Device Management > Licensing Activation Key page. For the An圜onnect licenses, you receive a multi-use PAK that you can apply to multiple ASAs that use the same pool of user sessions. You will then receive an email with a Product Authorization Key (PAK) so you can obtain the license activation key. If you want to upgrade from the Base license to the Security Plus license, or purchase an An圜onnect license, see. If you need to manually request the Strong Encryption license (which is free), see. You can optionally purchase an An圜onnect Plus or Apex license. It also comes pre-installed with the Strong Encryption (3DES/AES) license if you qualify for its use. The ASA 5500-X includes the Base or Security Plus license, depending on the version you ordered. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |